Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2011 BMW 328I Xdrive — assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its 17-character VIN to decode that exact car — its engine, trim, assembly plant and factory equipment — alongside these records. Free, no account.
Run a VIN →Recalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every BMW 328I Xdrive year.
Over 5 years this costs $7,750 more in fuel than an average new vehicle.
1 open NHTSA investigation into this model. Investigations come before recalls, so these are potential defects not yet covered by one.
Rated configuration: 2011 BMW 328 I Xdrive SW 4WD
HTTP 400 Bad Request
The parts named most often across 679 owner complaintsfiled with NHTSA for this make, model and year — the closest free answer to “what is likely to go wrong?”
6 fires · 1 injured
1 crash · 6 fires
9 crashes · 9 injured
8 fires
3 fires
1 fire
1 crash · 1 injured
Complaints are self-reported and skew toward problems people find alarming, so treat this as where to look, not a defect rate.
I brought my vehicle to an authorized dealer for three open safety recalls. Two were performed at no charge. The third, the VANOS adjustment unit screw connection recall, was not performed. The dealer stated in writing on the repair order that the vehicle has a broken valve cover bolt, that the valve cover will not seal properly, and that a new valve cover is recommended to complete the recall. They quoted $1,077.43 for a valve cover as a customer-pay repair and stated the recall could not be completed until that was done. I declined the valve cover. The recall was not performed. The bolt is not broken and the valve cover is not broken. The threads in the cylinder head bolt boss are stripped, and a larger bolt was installed that holds. There is no oil leak. A new valve cover would thread into the same stripped hole in the cylinder head and would not repair the damaged threads. The dealer's proposed repair does not address the condition they described. The manufacturer's dealer bulletin for this recall lists a cylinder head cover profile seal as a recall part and does not list a valve cover in any parts list. The remedy requires removing the cylinder head cover regardless. I left without signing the repair order. The recall remains open. I am reporting that a free safety recall remedy was conditioned on a customer-pay repair. The dealer could have performed the recall, documented the pre-existing thread damage on the repair order, noted that the customer was advised and declined the valve cover, and disclaimed responsibility for any future seepage at the cover. I would have accepted that. Instead they performed neither the recall nor any repair, and left a federal safety recall open.
The contact owns a 2011 BMW 328I. The contact stated that upon starting the vehicle, the low oil pressure warning light illuminated, and the vehicle stalled. The vehicle was towed to an independent mechanic, where it was diagnosed, and determined that the VANOS bolts had failed and needed to be replaced. The vehicle was not repaired due to the cost. The contact related the failure to TSB Number: SIB 11 04 14. The manufacturer was notified of the failure and informed the contact that the vehicle was covered under the TSB. The failure mileage was approximately 157,637.
The contact owns a 2011 BMW 328I. The contact stated that on several occasions while driving on the streets and the highway, the vehicle lost automotive power. There were no warning lights illuminated at the time of the failure. The contact stated that the vehicle jerked unexpectedly, stalled, and failed to accelerate over 30 MPH. The vehicle was towed to an independent mechanic but was not diagnosed or repaired. The mechanic referred the contact to the dealer for further assistance and stated that the failure could be related to a recall. The vehicle was towed to the dealer, but was not diagnosed or repaired. The contact stated that the failure started after the vehicle was repaired under an air bag recall by the dealer, and the failure persisted. The manufacturer was made aware of the failure. The approximate failure mileage was 200,000.
The contact owns a 2011 BMW 328I. The contact stated that while driving at various speeds, there was a burning odor coming from the vehicle. The odor was more prominent while the vehicle was idling. The RPM fluctuated while idling, causing the vehicle to stall. The contact would depress the brake pedal, place the vehicle in neutral, turn off, and restart the vehicle to accelerate and continue driving. The air bag warning light was illuminated, and the message, "Check Engine Soon," was displayed. The vehicle was taken to a certified mechanic, and a diagnostic code was retrieved for Positive Crankcase Ventilation (PCV) failure; however, no repairs were completed. The contact completed some research and learned that the failure could be occurring due to air entering the brake lines. The contact also found information about NHTSA Campaign Number: 22V119000 (Engine); however, the VIN was not included. The vehicle was not taken to the dealer, diagnosed, or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 133,000.
Fuel Pump Control Module and Fuel Pump Failed at highway speeds. There was a notification warning for a failed fuel pump and then the engine shut down and stalled at highway speeds within seconds.
> While driving the car, low oil pressure indicator came on and within less than a mile later there was a sudden loss of power, engine stalled and then would not start again, requiring vehicle to be towed off the road and to a repair garage. Yes, vehicle is available for inspection upon request. >Vehicle was immobile on the road putting driver of vehicle and other vehicles on the road at risk of accident and injury. > Attached documentation reviews the issue. > Vehicle originally inspected by non-dealership garage that strongly recommended the vehicle be evaluated by BMW. Vehicle was towed to and inspected by BMW Sewickley [XXX] . BMW states not covered under Vanos recall. >Only immediately prior to stall. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
> While driving the car, the low oil pressure indicator came on, and within less than a mile later there was a sudden loss of power, engine stalled and then would not start again, requiring the vehicle to be towed off the road and to a repair garage. > Vehicle was immobile on the road putting driver of this vehicle and other vehicles on the road at risk of an accident and injury. > Vehicle originally inspected by non-dealership garage that strongly recommended the vehicle be evaluated by BMW. Vehicle was towed to and has been inspected by BMW Sewickley [XXX] . > Only immediately prior to stall. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Engine lost all oil pressure, smoke came through vents with the smell of burnt oil. Engine stalled, intake camshaft no longer moves when the engine is trying to turn over. Vanos system failed.
The power cable to my battery needed to be replaced from the front to the rear. This seems like the recall NHTSA CAMPAIGN ID: 13V044000 but my car was not listed for it.
The contact owns a 2011 BMW 328I. The contact stated that while driving approximately 65 MPH, the check engine warning light illuminated, and the vehicle hesitated and stalled. The vehicle was restarted several times but continually stalled. The vehicle was later towed to the residence. The contact examined the engine and discovered metal shavings in the VANOS solenoid engine oil. The cause of the failure was not yet determined. The local dealer and manufacturer were notified of the failure. The vehicle was not yet repaired. The failure mileage was 120,000.
The contact owns a 2011 BMW 328I. The contact stated that while driving at an undisclosed speed, the contact noticed an abnormal dinging sound coming from underneath the hood. The vehicle was taken to the dealer where it was diagnosed with a detached VANOS bolt. The contact was informed that the failure was due to unrepaired recall NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling). The recall repair was performed. The vehicle was repaired. The contact stated that when the vehicle was released to the contact, the contact stated that the vehicle was shaking violently, and the RPM was fluctuating. In addition, the engine shut off while idling. The contact stated that the failure occurred before leaving the dealer. The dealer requested that the vehicle remain at the dealer for inspection. The vehicle was taken back to the dealer the following day. The vehicle was inspected, and the contact was informed that the failure was not related to the recall. The contact was requested to provide a diagnostic fee for further diagnostic tests and the contact declined. The contact stated that the vehicle was in worse condition after the recall repair was performed. The manufacturer was not made aware of the failure. The failure mileage was 91,000.
Footwell module (FRM) module went out after negative battery disconnect to change fuse. Module being inoperable is causing windows to not operate,interior lighting not working, headlights stay dim (not good for nightime driving), blinkers inoperable (not good for driving with windows not working- no arm signals), dash light also inoperable.
Showing 12 of 679 complaints.