Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2015 BMW M3, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every BMW M3 year.
NHTSA lists 3 recalls for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: BMW North America, LLC (BMW) is recalling certain model year 2016 BMW M2 Coupe vehicles, 2015-2017 M3 Sedan vehicles and 2015-2016 M4 Coupe and M4 Convertible vehicles. During servicing of the rear differential for a prior service action, the rear sub-frame bolts may have been reused instead of being replaced. Reuse of the existing bolts may cause the bolts to loosen.
Risk: Loose rear sub-frame bolts may adversely affect vehicle handling and control, increasing the risk of a crash.
Remedy: BMW will notify owners, and dealers will replace the rear sub-frame bolts with new bolts, free of charge. The recall began on November 3, 2016. Owners may contact BMW customer service at 1-800-525-7417.
Campaign 16V653000
Issue: BMW of North America, LLC (BMW) is recalling certain model year 2015-2016 M3 Sedan vehicles manufactured May 30, 2015, to September 2, 2015, 2016 M4 Coupe vehicles manufactured July 3, 2015, to September 11, 2015, and 2015-2016 M4 Convertible vehicles manufactured May 29, 2015, to August 4, 2015. The affected vehicles have a driveshaft with a slip-joint that may not have been filled with grease. As a result, the slip-joint may fail over time.
Risk: If the slip-joint fails, there would be a loss of power to the rear axle and therefore the vehicle would stop moving, increasing the risk of a crash.
Remedy: BMW will notify owners, and dealers will inspect the driveshaft, replacing it as necessary, free of charge. The recall began on January 14, 2016. Owners may contact BMW customer service at 1-800-525-7417.
Campaign 15V782000
Issue: BMW of North America, LLC (BMW) is recalling certain 2014-2015 2 Series Coupe (228i, 228i xDrive, M235i), 3 Series Sedan (320i, 320i xDrive, 328i, 328i xDrive, 335i, 335i xDrive, M3, 328d, 328d xDrive), 4 Series Coupe (428i, 428i xDrive, 435i, 435i xDrive, M4), and 2015 4 Series Gran Coupe (428i, 428i xDrive, 435i, 435i xDrive) vehicles. The head air bag inflator may fail at the weld joint, which can cause gas to leak from the inflator or result in an inflator rupture.
Risk: An inflator that ruptures may cause sharp metal fragments to enter or exit the vehicle, increasing the risk of injury. Additionally, an inflator that leaks gas may only partially inflate during a crash, increasing the risk of injury.
Remedy: Dealers will replace the head air bags, free of charge. Owner notification letters were mailed November 4, 2024. Owners may contact BMW customer service at 1-800-525-7417.
Campaign 24V288000
The parts named most often across 4 owner complaints filed with NHTSA for this make, model and year.
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
Gas tank has a significant leak. This allows for the opportunity to ignite the car putting all persons lives in danger, and effects emissions. Problem has been confirmed by independent Indy shop technician
Fuel tank top weld has failed, and is actively leaking fuel. This is likely to cause ignition of the vehicle during use and poses a threat to the lives of passengers and other drivers on the road as well as emissions failure. The failed weld was confirmed by independent Bmw technician. This part is a known failure point, and emission extended warrantee has been established for identical cars of the given make/model/year. The car has limited miles, no structural or cosmetic damage causing this failure. The car is not drivable as it poses a threat to safety.
REAR VIEW CAMERA STOPPED WORKING, SCREEN DISPLAYS "NO SIGNAL". FUSE DID NOT BLOW.
CRANK HUB SPUN TIMING SPROCKET CAUSING VALVES TO IMPACT PISTON AND CATASTROPHIC ENGINE FAILURE. QUOTED MORE THAN $10K OUT OF POCKET TO REPAIR. THIS IS CAUSED DUE TO POOR CRANK HUB DESIGN. CAR COMPANIES HAVE BEEN USING KEYED CRANKHUBS FOR GENERATIONS BUT BMW DECIDED TO NOT USED A KEYED HUB.. THIS IS VERY NEGLIGENT CONSIDERING HOW MANY OF THESE VEHICLES HAVE ENGINE FAILURE DUE TO THIS.
Rated configuration: 2015 BMW M3 4 DR RWD
Over 5 years this costs $9,000 more in fuel than an average new vehicle.