STEERING,POWER TRAIN,SERVICE BRAKES03/13/2026
Vehicle experienced a catastrophic mechanical failure characterized by a percussive "shotgun blast" noise from the rear chassis, followed by an immediate, total loss of braking power (pedal to the floor) and a violent loss of directional stability. This incident represents an aggravated safety failure of known GMT900 platform defects. The technical chain of causality began with the factory exhaust manifold fasteners suffering a metallurgical shear, a universal defect documented under GM Bulletins 19-NA-218, PIP5075, and PIP4701. This shear created a high-velocity, high-heat exhaust leak directed at the brake master cylinder and vacuum assembly. This "heat soak" event compromised the engine-mounted mechanical Brake Vacuum Pump (Recall N192268490 / NHTSA 19V645) and destroyed the internal seals of the Master Cylinder (Special Coverage 15143 / NHTSA 11V599), resulting in total depletion of vacuum assist and hydraulic pressure. Simultaneously, the "shotgun blast" and violent swerve were caused by structural failure consistent with Rear Brake Caliper Bolt Fracture (GM 13247 / NHTSA 13V342) and Rear Axle Shaft/Pin Fracture (GM 14892 / NHTSA 14V819). This mechanical collapse caused the caliper to strike the wheel, resulting in a catastrophic rim blowout and immediate loss of tire pressure. Despite the vehicle having aftermarket long-tube headers installed, the root cause of the heat-related brake failure was the failure of the OEM GM manifold fasteners which snapped off in the cylinder head, as documented in the aforementioned bulletins. Under the Magnuson-Moss Warranty Act, the manufacturer remains liable for these pre-existing safety-critical defects. The vehicle is at Glenn Polk Chevrolet for a 901-series Product Allegation Investigation (Case #90199492). This report is filed to demand federal oversight into these life-threatening defects. The combo of failed fasteners, rim blowout, and compromised braking created a vehicle that was both unable to be steered or stopped
STRUCTURE09/11/2025
The door handle broke off on the driver side the passenger side door handle will not open the door the outside handles are loose and the rear back driver and passenger side will not open their doors.
UNKNOWN OR OTHER07/26/2025
Frame falling apart the coating peeled off was going to clean it to recoat it but the metal is so far gone took it to a frame shop only to find out it's not drivable anymore GM have to do better with the coating for this trucks
STRUCTURE,UNKNOWN OR OTHER07/08/2025
2011 GMC Sierra Frame Failed Pennsylvania State Inspection due to Driver Side Frame Rust/hole. The section of the frame must be replaced due to rust(Improper coating... The truck has only 69700 miles on the odometer.
ELECTRICAL SYSTEM04/18/2025
Odometer Fraud. The contact purchased a 2011 GMC Sierra 1500. The contact stated that while attempting to register the vehicle, it was discovered that there was a mileage discrepancy. The vehicle was a private sale. At the time of purchase, the mileage was 119,000, and at the time of registration, it was discovered that the mileage was 128,000.
STRUCTURE01/27/2025
Vehicle is up for inspection in February of 2025 and due to the frame rust it will not pass.
ELECTRICAL SYSTEM,FORWARD COLLISION AVOIDANCE12/12/2024
When I put the truck in 4wd the dash says service stabilitrak and the traction control light and abs light come on
STRUCTURE09/16/2024
My GMC which is well cared for and only has 121,000 miles has a rusted through frame (mid-vehicle, left side) which has made the truck unsafe to drive. The steel used is inferior, my neighbor across the street also has this truck, 2 years newer, and is doing the same thing. As I have researched this issue I have found out that this is a critical failure of the GMC Sierra for several model years due to a failure to protect the steel used in northern states which compromises structural integrity. When Toyota had this issue, they stepped up and replaced the frames. General Motors, please tell me what you intend to do with this. It is a 5.3 Litre with 121,000 miles on it, in other words, still a baby for such a fine engine. This is not right. I am seriously discouraged. For my family, this is devastating. I still owe $2000 on this vehicle. Thank you, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
AIR BAGS08/13/2024
See attached document for complaint
POWER TRAIN07/22/2024
Transmission won’t shift
FUEL/PROPULSION SYSTEM05/29/2024
Over the past few years squirrels have eaten through the fuel line of the truck just above the fuel tank multiple times. As soon as the ignition switch is turned on fuel gets pumped out very near the exhaust system. The driver may not notice anything wrong immediately causing a very real fire risk. Today is the fourth time I have experienced this issue with this truck.
UNKNOWN OR OTHER04/28/2024
This is not a safety item, but one that causes undue financial hardship for the owner. It is widely know that the dash on certain 2007-2014 GM vehicles (generally trucks and SUV's) is susceptible to cracking. This causes devaluation of the vehicle if not fixed and is reported to cost between $2,000-2,500 to repair. It is my opinion that the cause of this is the use of substandard parts by GM and they should issue a recall for the repair of the dash.
Showing 12 of 365 complaints.