Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2011 Nissan Altima, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Nissan Altima year.
NHTSA lists 1 recall for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: NISSAN IS RECALLING CERTAIN MODEL YEAR 2011-2012 NISSAN ALTIMA SEDAN VEHICLES MANUFACTURED FROM APRIL 25, 2011, THROUGH JUNE 10, 2011 AT THE CANTON, MISSISSIPPI PLANT. THE TRANSVERSE LINK BOLT MAY NOT HAVE BEEN TORQUED TO THE PROPER SPECIFICATION. THIS CONDITION COULD CAUSE THE BOLT TO BECOME LOOSE WHILE THE VEHICLE IS BEING DRIVEN, CREATING A RATTLING NOISE AND VIBRATION.
Risk: IF THE BOLT COMES OUT COMPLETELY, THE DRIVER MAY EXPERIENCE DIFFICULTY CONTROLLING THE DIRECTION OF THE VEHICLE WHICH COULD RESULT IN A CRASH.
Remedy: NISSAN WILL REPLACE THE TRANSVERSE LINK BOLTS AND NUTS AND TIGHTEN THEM TO THE PROPER TORQUE SPECIFICATION FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 8, 2011. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Campaign 11V371000
The parts named most often across 241 owner complaints filed with NHTSA for this make, model and year.
1 crash · 2 injured
1 fire
3 crashes · 2 injured
1 fire
1 crash · 2 injured
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
What component or system failed or malfunctioned, and is it available for inspection upon request? The Engine Control Module (ECM) is malfunctioning, triggering persistent P0101 codes related to the Mass Air Flow (MAF) sensor. This specific issue is addressed in Nissan Technical Service Bulletin DE97AA, which recommends an ECM reprogramming. The component is still installed in the vehicle and is available for inspection. ⸻ • How was your safety or the safety of others put at risk? When the vehicle is at a complete stop and I attempt to accelerate, it becomes jumpy and unresponsive, refusing to accelerate properly. This creates a serious safety hazard, especially when trying to merge into traffic or cross intersections, as I am unable to match the speed of other vehicles. This increases the risk of being rear-ended or causing an accident due to unexpectedly slow acceleration. ⸻ • Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. An independent mechanic diagnosed the issue and confirmed the code P0101. After reviewing Nissan’s official TSB DE97AA, they advised me to go to a Nissan dealership to have the ECM reprogrammed as outlined in the bulletin. ⸻ • Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? The vehicle was inspected by an independent mechanic, but not yet by the manufacturer. The dealership is aware of the issue but has refused to perform the repair without payment. ⸻ • Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? Yes. The Check Engine Light is consistently triggered by code P0101, and the traction control warning light also comes on when the issue is active. The symptoms appeared recently and continue to recur even after the code is reset by standard non-dealership methods like unplugging the battery.
Drive axle suddenly not functioning properly, caused dangerous conditions to stop the car while driving on highway.
This is the second nissan altima iv owed an the problem eatch one iv had is that were the idler tensioner pully gose and bolts to brakes so there for you cant put the idler tensioner pully back on
What component or system failed or malfunctioned, and is it available for inspection upon request? The Engine Control Module (ECM) is malfunctioning, triggering persistent P0101 codes related to the Mass Air Flow (MAF) sensor. This specific issue is addressed in Nissan Technical Service Bulletin DE97AA, which recommends an ECM reprogramming. The component is still installed in the vehicle and is available for inspection. ⸻ • How was your safety or the safety of others put at risk? When the vehicle is at a complete stop and I attempt to accelerate, it becomes jumpy and unresponsive, refusing to accelerate properly. This creates a serious safety hazard, especially when trying to merge into traffic or cross intersections, as I am unable to match the speed of other vehicles. This increases the risk of being rear-ended or causing an accident due to unexpectedly slow acceleration. ⸻ • Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. An independent mechanic diagnosed the issue and confirmed the code P0101. After reviewing Nissan’s official TSB DE97AA, they advised me to go to a Nissan dealership to have the ECM reprogrammed as outlined in the bulletin. ⸻ • Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? The vehicle was inspected by an independent mechanic, but not yet by the manufacturer. The dealership is aware of the issue but has refused to perform the repair without payment. ⸻ • Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? Yes. The Check Engine Light is consistently triggered by code P0101, and the traction control warning light also comes on when the issue is active. The symptoms appeared recently and continue to recur even after the code is reset.
There is issue with sunroof drainage tubs causing rain to soak the floor of car. This definitely malfunction or inadequate problem with drainage tubs and sunroof parts with Nissans. I took it to the dealership and car collision repair shop and was told this is high reoccurring issue with Nissan sunroofs, but no recalls have been given, and I have to pay out pocket to get fixed. At 1st was told just get the drains cleaned out and you shouldn't have that problem again. The issue has progressed and now I have paid for drains to get unclogged 2x so far in one year and keep happening every time its alot of rain at one time. My only option I'm told is to keep getting drains cleaned and unclogged pay out of pocket or get another car without sunroof. I have gotten this done 2 years in row, that's getting too expensive to pay. That's not fair when you know it's problem with these drains and don't do nothing to fix issues. I like cars with sunroofs and have no control over when it rains. I should be able to have a car in 2025 with sunroof and not have this problem. Please help with this issue with factory sunroofs made in original cars not added. Make better drainage system for sunroofs in Nissan and all cars.
I have complained to Nissan that the dash in the car is literally melting. It started around 2014 when I noticed it was having a sticky texture and because of this it creates a glare in the windshield that makes it hard to see. Over the years it has only gotten worse and the dash is literally crumbling. I read online where they have had this issue before. I have tried to get help locally but I am lost no one will help me. This is a really bad safety issue!
I brought my car to Florida 2 years ago and notices my dashboard getting very shiny and sticky. Now the dash is cracking in many areas. The glare off the dash board shining on the windshield makes it a dangerous situation. I called Nissan and they said it is a common problem in years 2005-2012 and there is nothing they can do. I googled it and there are many complaints online regarding this problem. A 13 y/o car that was garaged for 11 years in the NE and now parked underneath a parking garage should not have this problem. It is definitely a defect in manufacturing that is causing a safety issue and a diminished value issue.
While driving it's difficult for the car to shift gears, also a burning smell comes from the engine after driving long distance.
Unknown. My car is making a whining noise & no matter how much i push the gas pedal it won’t accelerate. Sometimes it works but mostly it won’t.
Airbag sensor flashing. Seems to be a very common issue and no recall. Found tons of articles and YouTube videos.
It started about 2 months ago that the RPM was revving when it came to the gears shifting. I would accelerate and the car would barely move and the transmission was making a whirring sound. The Service Engine Soon light came on so I took my car to O Reilys and the code for the stepper motor came back. I had the stepper motor replaced in my transmission but I am having the same issue. My Mechanic told me that my Transmission is failing and I would need a brand new one.
REAR SUB FRAME IS RUSTED OUT AND WILL NOT PASS STATE INSPECTION. YES IT IS AVAILABE FOR INSPECTION. FRAME COULD BREAK AT ANY TIME AND CAUSE A ACCIDENT .
Showing 12 of 241 complaints.
Rated configuration: 2011 Nissan Altima 2 DR FWD
28.4 mpg average · 25–33 range · EPA says 26
Over 5 years this costs $750 more in fuel than an average new vehicle.