Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2009 Ram 1500, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Ram 1500 year.
No EPA fuel-economy match for this model. Naming may differ, or it predates EPA records.
NHTSA lists 2 recalls for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: Chrysler (FCA US LLC) is recalling certain 2016-2017 Ram 3500 Cab Chassis with a Gross Vehicle Weight Rating (GVWR) of less than 10,000 lbs, 2011-2017 Ram 3500, 4500 and 5500 Cab Chassis vehicles, 2009-2017 Ram 1500 and 2010-2017 Ram 2500 and 3500 pickup trucks, all equipped with a column shifter. Pushing the brake pedal for prolonged periods when the vehicle is running and in PARK may cause the Brake Transmission Shift Interlock (BTSI) pin to stick in the open position. With the pin in the open position, the transmission can be shifted out of PARK into any gear without pushing the brake pedal or having the key in the ignition.
Risk: Being able to shift the transmission without pushing the brake pedal and/or without a key in the ignition can increase the risk of an unintended vehicle rollaway that may result in personal injury or a crash.
Remedy: Chrysler will notify owners, and dealers will update the vehicle software, inspect the BTSI, and, as necessary, replace it, free of charge. The recall began February 26, 2018. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is T79.
Campaign 17V821000
Issue: Chrysler (FCA US LLC) is recalling certain 2009-2012 Dodge Ram 1500 trucks currently, or ever registered, in Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, Wisconsin and the District of Columbia. Exposure to environmental conditions such as water mixed with road salt may cause the front fuel tank strap frame "T-Slot" bracket to corrode, possibly causing the fuel tank to drop and make contact with the ground.
Risk: If the fuel tank were to drop and contact the ground, a fuel leak may result. Additionally, in the event of a crash, the fuel tank may not remain secured to the vehicle, possibly causing a fuel leak. A fuel leak in the presence in an ignition source, can increase the risk of a fire.
Remedy: Chrysler will notify owners and dealers will bolt a bracket reinforcement to the frame, free of charge. The recall began May 2, 2018. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is U04.
Campaign 18V160000
NHTSA has no NCAP crash-test rating for this model year, which is common for older, low-volume and heavy-duty vehicles.
The parts named most often across 37 owner complaints filed with NHTSA for this make, model and year.
1 injured
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
The contact owns a 2009 Ram 1500. The contact stated that upon purchasing the vehicle, it was discovered that there were two open recalls on the VIN, NHTSA Campaign Number: 13V038000 (Power Train) and 17V821000 (Power Train). The contact scheduled an appointment with a dealer, and the vehicle was repaired under the recall. Upon picking the vehicle and exiting the parking lot, the contact heard an abnormal whining sound coming from the vehicle, and the check engine warning light illuminated. The vehicle was taken back to the dealer and remained with the dealer. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 120,000.
I bought this 2009 Dodge ram Laramie about a year ago been riding like new but 4 days ago starting to hear a bad whining noise from the rear end and I see this truck had a recall on the pinion nut I think it's coming lose from the pinion
The contact owns a 2009 Ram 1500. The contact stated that the air conditioner, heater, and defogger were inoperable. The climate control warning light was not illuminated. The contact replaced the climate control module; however, the failure persisted. The manufacturer was not notified of the failure. The approximate failure mileage was 200,000.
Frame rail has rusted out causing this vehicle unsafe to drive. A quick google search showed this a common problem. I know Mercedes Benz have recalled rusting brake boosters and provided extended warranty on rear subframe rust. Toyota has recalled truck frames. Dodge is ignoring this issue.
In researching the vin for my vehicle, a 2009 Dodge Ram 1500, it shows there are no recalls on it but I've recently found that the front fuel tank bracket has rusted out of the frame of the vehicle I believe this VIN should fall under Safety Recall U04 / NHTSA 18V-160 Frame Bracket. This is the subject of that Safety recall which has impacted my vehicle: The front fuel tank strap on about 287,000 of the above vehicles may detach due to the frame bracket corroding. Detachment of the front fuel tank strap could potentially allow the front of the fuel tank to make contact with the ground, increasing the risk of a fuel leak. A fuel leak in the presence of an ignition source could result in a fire.
When driving the vehicle at lower speeds, usually between 25 to 38 mph, the engine will surge for about 1 to 2 seconds then back to normal as long as I remain in that speed range. It happens each time within that range of speed.
I purchased this vehicle from a private party and insured it and my insurance offers free carfax after checking through its history i see that it has 2 pending recalls and one of them has a buyback program, i called dealerships and the Chrysler warranty phone number but they do not want to buy it back even though that is one of the remedy's , the main problem is with the driveshaft which can separate due to a axle pinion bolt and cause an accident i really do not want to deal with these recalls and would rather go with the available option of having it repurchased from chrysler
Tipm causing horn to work not work goes off by itself. Locks don’t work windshield wipers stop working or don’t work at all. Airbags not working. Caused battery to overcharge and begin to smoke. Replaced battery
The hvac System behind dashboard stopped working and there is no air or heat it keeps making a loud clicking noise for about 1 minute and goes away and then 5 minutes later it does it again for another 5 minutes I took to a shop the said the hvac system behind the dash went out and you have to remove the whole dashboard and replace the whole hvac system to fix it I have no heat or a/c and I seen there are recalls concerning this matter
The third brake light stays lit even when key is off and gets extremely hot. rear brake lights come on when key is turned on making them indistinguishable from running lights. This happens even if brake pedal switch is removed!
Driving home from the store the rear end locked up, sheared off my drive shaft. Caused a slight skid. There was a low hum when I let off the gas. I thought it was road noise. It got louder as I got closer to home. As I hit the brakes to turn into my neighborhood it was very loud. As soon as I turned and hit the accelerator I heard a loud noise and started to skid into the curb. There as a loud banging as my drive shaft spun and hit everything under my truck.
Took the truck in for tire rotation and was told they couldn't do it due to the rear frame being severely rusted out I have noticed this is a very common problem with this year truck in the same area mine is rusted out
Showing 12 of 37 complaints.