Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2019 GMC Yukon, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every GMC Yukon year.
NHTSA has issued a do-not-drive warning covering 1 recall on this make, model and year. Repairs are free at any franchised dealer.
Recalls are issued per model. Confirm whether this specific car has already been repaired using its VIN, free, at any franchised dealer or on nhtsa.gov/recalls.
NHTSA lists 2 recalls for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: General Motors, LLC (GM) is recalling certain 2026 Cadillac Escalade and Escalade ESV, Chevrolet Silverado 1500, Suburban, and Tahoe, and GMC Sierra 1500, Yukon, and Yukon XL vehicles with four-wheel (4WD) or all-wheel drive (AWD), and certain 2015-2020 Suburban, Escalade, Escalade ESV, Yukon, Yukon XL, and Tahoe vehicles. A component missing from the drivetrain transfer case may cause the front and/or rear wheels to lock up without warning to the driver.
Risk: Front or rear wheel lockup increases the risk of a crash.
Remedy: Owners are advised not to drive their vehicle until the remedy is completed. Dealers will inspect and, if necessary, replace the transfer case assembly, free of charge. Owner notification letters were mailed May 18, 2026. Owners may contact GMC customer service at 1-800-462-8782, Chevrolet customer service at 1-800-222-1020 or Cadillac customer service at 1-800-333-4223. GM's number for this recall is N262557620. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on May 7, 2026.
Campaign 26V289000
Issue: General Motors LLC (GM) is recalling certain 2015-2020 Chevrolet Suburban, Tahoe, and GMC Yukon, and 2014-2018 Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles equipped with a 5.3-liter engine, a 3.08-ratio rear axle and four-wheel drive. If a wheel-speed sensor fails, while the vehicle is traveling between 41 and 60 mph in four-wheel or automatic mode, the Electronic-Brake Control Module (EBCM) software may activate the driveline-protection system.
Risk: Unintended activation of the driveline-protection system will cause unintended braking on the wheel on the opposite side of the failed sensor, causing the vehicle to pull to one side unexpectedly, increasing the risk of a crash.
Remedy: GM will notify owners, and dealers will reprogram the EBCM, free of charge. The recall began December 11, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192261050.
Campaign 19V761000
The parts named most often across 54 owner complaints filed with NHTSA for this make, model and year.
2 injured
Yukon would not idle without turning off on its own. Check engine light came on. Took it to my mechanic. Check engine light was flashing which indicated an active misfire. A running compression test found little to no compression from cylinder 6. Further investigation found that cylinder 5 had been repaired in 2022. Mechanic recommends engine replacement.
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
My wife drives this vehicle to work, it has started to experience reduced engine power driving on the highway causing her to pull to the side of the road due to no throttle to maneuver the vehicle in and out of traffic, leaving her on the side of the busy highway, we have now parked the vehicle after investigating problem there is a knocking noise coming from the lower part of the engine, after research of this 6.2l engine there are reports of the crankshaft and connecting rods seizing up and coming through the side of the engine block, knowing this we are hesitant to continue driving the vehicle. We continue to make payments on a vehicle that we can't use and can't afford to make a engine replacement at the moment. Very frustrating to say the least, as expensive as these vehicles are we have lost faith in the gm name.
Vehicle shudders at acceleration at times making merging onto highways and passing vehicles dangerous.
The vehicle experienced a sudden and rapid mechanical failure of the 6-speed automatic transmission (6L80 model) within a span of less than two weeks. The light did not come on until the transmission was past salvage. The failure escalated rapidly from initial minor slipping to a severe loss of vehicle propulsion. A loss of acceleration while driving poses an immediate crash hazard, as the vehicle cannot safely maintain speed with surrounding traffic or accelerate out of dangerous situations. The failure required towing and a complete out-of-pocket replacement of the transmission unit at 116,374 miles to restore safe operation. The manufacturer has failed to issue a safety recall despite widespread failures of this component causing unexpected power loss on public roadways.
Transmission is acting funny. Stuck in low gear /not shifting at low speeds. Vibration sometimes at higher speeds when shifting gears. 8 9 10 gears.
I was driving home on the interstate from vacation and I was set on cruise control it was 1 am so not a lot of traffic was on the road thank god. It could have been really terrible if lots of traffic was present as the engine just died without notice! The vehicle was decelerating nothing was working I could not speed up. I was able to get over to the side of the road. I got a notification on my phone that said battery critically low start vehicle to charge battery. Well nothing would start at this point. I lot all power seconds later. I thought that the cruise control was locked up and restarting it would reset it. I called roadside assistance to get a jump and that did not work. I got towed into an auto repair shop. They called me and told me that the engine is locked up that they drained the oil and found metal in it and metal pieces in the oil filter as well. They checked for leaks and said there was none that they could find. They said there was a recall but it was for the exact same symptoms that was diagnosed here but only starting with year 2021. Mine is a 2019 Yukon Denali with low mileage so not sure if all the other Yukons were aged out or already past engine death and that’s why they were not part of this but this should be included in with the open recall considering how everything is the same that is effecting this year that I have and they should pay for a new engine! Clearly the v8 6.2 gmc engines are having major issues I’m just glad I wasn’t going that fast and traffic was slow so I was able to get over safely before catastrophic things happened since there was no warning when this all happened!
Getting the valve ticking noise.
The contact owns a 2019 GMC Yukon. The contact stated that after starting and exiting the vehicle to allow it to warm up, the contact later noticed that the vehicle had turned off. The vehicle was towed to a first mechanic, who was unable to restart the vehicle or determine the cause of the failure. The vehicle was towed to a second mechanic, where it was diagnosed and determined that the engine had failed and needed to be replaced. The vehicle was not repaired due to the cost. The dealer was contacted and provided an estimate for the repair, but the vehicle was not diagnosed or repaired. The contact stated that the dealer's estimate was higher than the mechanic's estimate. The manufacturer was notified of the failure and suggested purchasing a new vehicle. The failure mileage was approximately 170,000.
Complete engine failure. The dealership kept the engine. This happened at a low rate of speed but it would have been much worse if on the highway. Yes the engine was completely replaced. The check engine light came on and their was a loud ticking noise coming from the engine.
The contact owns a 2019 GMC Yukon. The contact stated that while driving at slow speeds in a parking lot, the transmission unexpectedly downshifted and the vehicle jerked abnormally. The contact stated that when the gear shift lever was shifted to drive(D), the vehicle failed to function as designed. The contact was unable to drive the vehicle, and the vehicle was towed to the residence. No warning light was illuminated. The vehicle was towed to the dealer, where it was diagnosed that metal shavings were found in the oil and the transmission needed to be replaced. The warranty had expired, and the vehicle was not repaired. The contact stated that the failure persisted. The vehicle was then taken to a transmission specialty shop, where it was confirmed that metal shavings were found in the oil and that the transmission was defective and needed to be replaced. The contact took the vehicle back to the private dealer where the vehicle was purchased. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 125,870.
I was driving on RT80 in NJ and my 2019 GMC Yukon lost power. I took it to my local Chevy dealer. The scan code was p0300 engine misfire. They removed right side valve cover and found no bent pushrods. Inspected camshaft and found damage from failed lifter. I had to get a new engine and pay out of pocket $14,435.44
2019 GMC Youkon with 94,659 miles. I am the second owner of this vehicle. I purchased it used in February 2025. Check engine light came on in route to work on March 5, 2026. Immediately took vehicle to Auto Zone to scan for codes. Multiple codes were returned. I drove it directly to a repair shop for further diagnostics. Return Results were massive lifter failure and cam shaft damage. Why would the check engine light not come on sooner to prevent TOTAL FAILURE. Vehicle was towed to a GMC certified mechanic where it was confirmed that all Lifters and cam shaft were damaged beyond repair and must all be replaced. Estimated Cost of repairs so far: $8,596.80 Labor: Remove & Replace Left And Right Valve Lifter (Both Sides) Coolant Service Oil Change Labor Parts: Engine Camshaft 1 , Genuine GM Engine Valve Lifter Oil Manifold Gasket 1 , Genuine GM Fuel Pump Gasket 1 Engine Timing Cover Gasket Set 1 Engine Valve Lifter Guide 1 Engine Valve Lifter Guide 1 Coolant/Antifreeze Orange Dex-Cool 1 Gal 3 Engine Push Rod 8 Engine Oil Filter 1 0W-20 Full Syn 8 Engine Cylinder Head Bolt Set 1 Engine Valve Lifter Guide 1 Engine Valve Lifter Guide 1 Stock Engine Valve Lifter 4 Stock Engine Valve Lifter 4 Engine Cylinder Head Gasket Kit 1 Engine Cylinder Head Bolt 10 APPROVED Subtotal $8,422.71 + est. Tax $174.09 $8,596.80 Estimated time for repair: going on three weeks
Showing 12 of 54 complaints.
No EPA fuel-economy match for this model. Naming may differ, or it predates EPA records.
Rated configuration: 2019 GMC Yukon SUV RWD