Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2020 Jeep Gladiator, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Jeep Gladiator year.
NHTSA lists 7 recalls for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: Chrysler (FCA US LLC) is recalling certain 2020 Jeep Gladiator vehicles. The rear driveshafts may have been incorrectly assembled without grease in the monoblock joint.
Risk: A joint without grease may overheat and seize, possibly causing the driveshaft to fracture, resulting in a sudden loss of drive power. If the driveshaft completely separates from the vehicle it may become a road hazard. Either of these scenarios can increase the risk of a crash.
Remedy: FCA US will notify owners, and dealers will replace the driveshaft, free of charge. The recall began October 10, 2019. Owners may contact FCA US customer service at 1-800-853-1403. FCA US number for this recall is V95.
Campaign 19V636000
Issue: Chrysler (FCA US LLC) is recalling certain 2019 Jeep Wrangler and Ram 2500, 2019-2020 Ram 1500 and 2020 Jeep Gladiator vehicles. In the event of a crash, a front seat belt retractor may not properly slow the occupant's forward movement after locking.
Risk: In the event of a crash, if the front seat belts fail to lock, there is an increased risk of injury.
Remedy: Chrysler will notify owners, and dealers will replace the front seat belt retractors, free of charge. The recall began November 12, 2020. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is W67.
Campaign 20V580000
Issue: Chrysler (FCA US LLC) is recalling certain 2020 Jeep Gladiator and Jeep Cherokee, 2019-2020 Ram 1500 Pickup, Ram 2500 Pickup, Ram 3500 Pickup, Chrysler Pacifica, Dodge Durango, Jeep Grand Cherokee, Jeep Wrangler, and Jeep Renegade and 2019 Dodge Challenger vehicles equipped with 8.4" or 12" radio displays. A software error can cause the rearview camera image to remain displayed after the vehicle has been shifted out of reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rearview Mirrors."
Risk: The lingering rearview image can distract the driver, increasing the risk of a crash.
Remedy: Chrysler has notified owners, and dealers will update the radio display software, free of charge. Optionally, owners can choose to remotely update their software via an Over-The-Air (OTA) update available as of May 1, 2020. The recall began April 27, 2020. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is W30-W37.
Campaign 20V191000
Issue: Chrysler (FCA US, LLC) is recalling certain 2018-2021 Jeep Wrangler and 2020-2021 Jeep Gladiator vehicles equipped with manual transmissions. The clutch pressure plate may overheat and fracture.
Risk: Overheated clutch components may increase the risk of a fire. Additionally, damage to other nearby components can result in debris falling onto the road or a loss of drive, increasing the risk of a crash.
Remedy: FCA US LLC will notify owners, and dealers will add software to reduce engine torque capability when clutch assembly temperatures rise to a level that may damage the inner pressure plate, free of charge." FCA has ordered a stop sale for the affected vehicles as of February 25, 2021. Owner notification letters were mailed on March 4, 2021.
Campaign 21V028000
Issue: Chrysler (FCA US LLC) is recalling certain 2018-2020 Jeep Wrangler and 2020 Gladiator vehicles equipped with manual transmissions. The clutch pressure plate may overheat and fracture.
Risk: The overheated clutch components may increase the risk of a fire. Additionally, damage to other nearby components can result in debris falling onto the road or a loss of drive, increasing the risk of a crash.
Remedy: Chrysler will notify owners, and dealers will reroute a wire harness and inspect the clutch system, and replace components as needed. The recall began April 30, 2020. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is W12.
Campaign 20V124000
Issue: Chrysler (FCA US, LLC) is recalling certain 2018-2023 Jeep Wrangler, and 2020-2023 Jeep Gladiator vehicles equipped with manual transmissions. The clutch pressure plate may overheat and fracture.
Risk: Overheated clutch components may increase the risk of a fire. Additionally, damage to other nearby components can result in debris falling onto the road or a loss of drive, increasing the risk of a crash.
Remedy: Dealers will replace the clutch assembly and update the software, free of charge. Owner notification letters were mailed from November 16, 2023 through July 25, 2024. Owners may contact (FCA US, LLC) customer service at 1-800-853-1403. FCA US LLC's number for this recall is 19A. This recall expands and replaces previous recall 21V-028. Vehicles previously repaired under recall 21V-028 will need to have the new remedy completed.
Campaign 23V116000
Issue: Chrysler (FCA US, LLC) is recalling certain 2020-2024 Jeep Gladiator and 2018-2024 Jeep Wrangler vehicles. The instrument panel cluster may experience an internal short circuit and fail. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 101, "Controls and Displays."
Risk: An instrument panel that fails to display critical safety information, such as the speedometer or warning lights, can increase the risk of a crash.
Remedy: Dealers will replace the instrument panel cluster, free of charge. Owner notification letters were mailed between October 3, 2024, and January 23, 2025. Owners may contact FCA customer service at 1-800-853-1403. FCA's number for this recall is 30B.
Campaign 24V652000
The parts named most often across 483 owner complaints filed with NHTSA for this make, model and year.
1 crash
1 crash · 2 fires
Instrument Panel Failure. The center LCD screen that displays speed, tachometer, oil temp, coolant temp, oil pressure, battery voltage, and transmission temps, fuel gauge, tire pressure readings, warning messages, and many other things just stopped working. This is obviously a safety risk and can cause an increased risk to safety and crashes, as it has been recalled on many other Jeep Gladiators and Wranglers. This screen started out working upon purchase, but would often have a digital background that would show up. The dealership it was purchased from informed us there was nothing wrong with the screen. It just stopped working and there is nothing on the display.
1 fire
1 crash · 1 injured
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
Clutch overheated and cause an immense amount of smoke during drive with no warning indication from hud. Dealer stated that clutch has gotten well passed 390c Heat from clutch has also caused front driver caliper to lock up and damage rotors.
the driver instrument cluster has failed. completely blank no fuel gauge no odometer. was told this vin is not covered under the recall even though this is the issue behind the recall.
My 3.5 instrument intermittently goes out for days and will come back on and back off again. I took it to the nearest dealer but this did not sjow up on his scan but it out again. As you will see in the photo the vehicle is running but no display. Milage is a little over 69,000. Dealer informed me that many of these were recalled but not my particular vehicle. He said it would cost me $1600 to get it repaired. It appears to me the recall may need to be expanded. I also contacted the jeep website but was told my vehicle was not covered under the recall.
The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at various speeds, the instrument panel failed to display critical safety information as intended. No warning lights were illuminated. The vehicle was taken to a local Midas, where the battery was replaced; however, the failure persisted, and the vehicle was diagnosed and determined to need a new instrument panel. The local dealer was contacted. The vehicle was not diagnosed or repaired due to the cost. The manufacturer was not made aware of the failure. The failure mileage was approximately 45,000.
The instrument Custer went blank during a vacation trip, did not know how much fuel was in it. Took to dealer they tried to put in a new one and it was also faulty, been waiting 3 weeks and still no new part
I was rear ended while stopped and the seat belts didnt lock causing injury to my face from hitting the steering wheel.
The digital dash that displays the speed, shows fuel level and if 4x4 is active went blank, when I went to turn my vehicle on
The start-stop system reports unavailable, then within a few miles of driving, the check engine light will come on, followed by problems with the transmission shifting gears, sometime causing the vehicle to stay in first or second gear while accelerating and creating a dangerous driving situation. Power cycling the vehicle sometimes helps. Diagnostic trouble codes show low voltage in one or more O2 sensors, "too lean" warnings and cylinders randomly misfiring. Engine runs very rough at idle with the strong smell of gas in the exhaust. Dash information shows battery voltage around 12.3 at start up increasing to low 13 while idling. This occured around 40,000 miles and dealer replaced the aux battery and reset system. It occurred again around 60,000 miles (20 months later) and owner replaced both auxiliary battery (testing showed bad) and main battery. System functioned normally after resetting codes. It occurred again about 8 months later at 72,000 miles. The F42 fuse was pulled, cleared codes and reset computer by removing battery power for 1 hour. System returned to normal.
TRUCK WOBBLIES WHEN DRIVING AT HIGHWAY SPEEDS. THE STEERING TAKES TWO TO THREE INCHES TO TURN THE STERRING WHEEL BEFORE THE TRUCK STARTS TO TURN. NOT RESPONSIVE AS IT WAS.
On May 27, 2026 at approximately 11:00 PM, my 2020 Jeep Gladiator Overland (VIN: [XXX] ) suffered catastrophic engine failure during normal operation at 78,190 miles. The alternator seized, causing the harmonic balancer (crankshaft damper) to fracture. The broken balancer fell into the engine block, causing extensive internal damage requiring complete engine replacement at significant cost. This failure sequence points to a design and/or manufacturing defect in the OEM alternator and/or its mounting system on the 3.6L Pentastar V6. A properly designed alternator should not seize with enough force to fracture the harmonic balancer and deposit debris into the engine block under normal operating conditions. The vehicle was not involved in any accident or operator abuse. It was being driven normally with no prior warning — no dashboard lights, no unusual sounds, no prior related mechanical issues. I request NHTSA investigate whether this failure pattern is systemic across 2020 Jeep Gladiator vehicles and other 3.6L Pentastar V6 platforms, including the Jeep Wrangler, Ram 1500, and Dodge Durango. Sudden complete engine failure at highway speeds is an immediate crash hazard to the driver and surrounding motorists. I respectfully request a formal defect investigation and, if warranted, a safety recall with full remediation and reimbursement of repair costs to affected owners. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
On Friday, May 22, 2026, at approximately 59,442 miles, the vehicle's instrument panel cluster (IPC) failed suddenly and without warning. The vehicle was driven to a store in [XXX] , with the display functioning normally, but upon restarting the vehicle less than an hour later, the central information screen went completely blank. The screen remains permanently blank and fails to display any driver information. At night, turning the vehicle on causes the screen to emit a faint dark gray backlight, but no text, gauges, or data populate. This failure creates an immediate safety hazard. With a permanently blank cluster, I am forced to drive without access to a speedometer, fuel gauge, odometer, or critical vehicle warning and safety lights, severely impacting my ability to maintain safe speeds and monitor vehicle health on public roads. The vehicle was inspected on May 27, 2026, by an authorized Jeep dealership (Lopp Motors in Dodge City, KS). The technician confirmed the failure and noted: "INFO SCREEN BETWEEN TACH AND SPEEDO IS BLANK. NO CODES IN SYSTEM PERTAINING TO CONCERN. TECH TRIED TO RESET CLUSTER AND PERFORMED PROXI ALIGNMENT – WOULD NOT ALIGN. ATTEMPT A VEHICLE CONFIG RESTORE – STILL NO CLUSTER OPERATION. INSTRUMENT CLUSTER REQUIRES REPLACEMENT." This identical component failure is the subject of NHTSA Campaign 24V-652 (Jeep Recall 30B); however, my 2020 model year VIN is currently excluded due to manufacturer time-in-service parameters. The vehicle and the failed component are available for inspection upon request. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Showing 12 of 483 complaints.
No EPA fuel-economy match for this model. Naming may differ, or it predates EPA records.
NHTSA frontal crash test
1 open NHTSA investigation into this model. Investigations come before recalls, so these are potential defects not yet covered by one.
Rated configuration: 2020 Jeep Gladiator PU/CC 4WD