2024 Jeep Gladiator

-The power steering pump electrical wiring harness/connector. The vehicle is subject to active Mopar safety Recall 21D (NHTSA Campaign 26v-363) for an un remedied vehicle fire risk caused by high electrical resistance. Yes, the vehicle and affected component are available for inspection upon request. -Due to the electrical fire risk, the manufacturer has issued an urgent federal directive stating the vehicle must be parked outside and away from structures until it is repaired. Because the manufacturer has not finalized or distributed a permanent replacement remedy, I am forced to store a known fire hazard near public spaces, putting my property and the safety of others at risk. Furthermore, a sudden loss of power steering assist while driving poses an immediate crash hazard. -Yes. The vehicle was brought to an authorized Mopar dealership for inspection on August 7, 2026. However, the dealership marked the repair order as "PARTIAL-COMPLETE" because physical remedy parts do not yet exist. Despite this lack of a physical fix, the manufacturer updated the administrative database to show "0 open recalls" in an attempt to prematurely close my customer retention file. -No active warning lamps or drivability symptoms have appeared yet. The "failure" in this instance is the manufacturer’s structural failure to provide the legally required, permanent safety remedy within a reasonable timeframe. The safety hazard and park-outside restrictions have been active and ongoing since the recall notice was formally issued.

This happened on a 2024 Jeep Gladiator. When parking I went to set the parking brake and as I pulled the handle I heard a pop and felt the handle release all pressure. With the handle up there was no braking effect. Dealer repaired by hooking the right wheel cable back onto the bracket located under the center console, and then adjusting.

Caught fire while driving

The contact owns a 2024 Jeep Gladiator. Upon research, the contact discovered that the VIN was included in NHTSA Campaign Number: 26V363000 (Steering); however, the part to do the recall repair was not yet available. The contact had not yet received the notification of the recall but was concerned about the fire risk associated with the recall. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure.

Factory installed Corning Gorilla Glass became marred and scratched from windshield wiper during rain fall. Glass also developed a crack in the right lower corner of the glass from unknown source (not a stone or road hazard). I requested the repair be covered under the original factory warranty and the repair was rejected. Per the dealership the glass is covered for 24/24 if NOT factory installed. It's covered for 12/12 if it IS factory installed. My windshield is factory installed and out of the 12/12 but still would have been covered under the 24/24 warranty otherwise. I see a lot of complaints about the Corning Gorilla windshields failing.

Electrical Fire Recall / NOT FIXED / Dealers and Jeep refuse to repair as there is no repair for it. Afraid to park this at home/work. Currently no signs other than steering feeling heavier over time.

I was driving my 2024 Jeep Gladiator Willys Texas Edition on the FM 3180 and I 10 when the vehicle experienced a complete electrical failure without warning. The instrument panel began flashing, the vehicle lost power and became completely inoperative while I was traveling. I was able to get the vehicle off the roadway, but it would not restart. At first it would start and flash, windshield wipers were on, even though control was off. It would go about 10 feet and die again for several minutes. I eventually got it off the road and into a parking lot where it beeped and clicked, but would not turn on. The vehicle had no electrical power. A roadside jump box had no effect. The tow operator had to manually override the transmission to place the vehicle in neutral so it could be loaded onto the tow truck. The vehicle was towed to the dealership and remains inoperable. This vehicle previously received a software repair/recall/update in 2025. I do not yet know whether this failure is related to that recall. This was a serious safety event because the vehicle completely shut down while traveling on a high traffic area. I believe this defect could create a significant risk of a crash if it occurs at a high rate of speed. I had no control of the vehicle at times.

My 2024 Jeep Gladiator is subject to Recall 21D (NHTSA 26V-363). The recall warns of a fire risk while parked due to overheating of an electrical connection. Owners have been instructed to park away from structures and other vehicles, but there is currently no remedy available. I am concerned about the safety risk and the lack of an available repair.

Called dealership about recall they told me they can not fix the problem. I can not park my car near a structure. So where am I parking my car. I asked if my car driving weird can be from this recall they told could be possible but they have no resolution for it.

My 2024 Jeep Gladiator Mojave has an ongoing brake issue that persists despite inspections by multiple dealerships. When starting the vehicle in the morning, the brake pedal is unusually hard and sits lower than expected, requiring excessive force before the engine will engage. Once the engine is running, pedal pressure returns to normal. For comparison, I also regularly drive a 2020 Jeep Gladiator and a 2023 Jeep Wrangler, neither of which exhibit this condition. Additionally, after driving for approximately one hour or longer, the vehicle experiences significant brake fade. Increased pedal pressure is required to slow or stop the vehicle, particularly during downhill driving. I routinely drive long distances between Seattle and Tucson and consider this a serious safety concern. In an attempt to address the issue, I spent several hundred dollars upgrading the braking system with ceramic brake pads and drilled rotors. While overall braking performance improved somewhat, the hard brake pedal during startup and brake fade issues remain constant and unresolved. I have worked extensively with two Jeep dealerships regarding this matter: Larry H. Miller Chrysler Jeep Tucson and West Hills Chrysler Jeep Dodge RAM. I also contacted a Jeep customer service representative, who advised that if dealership technicians could not identify a problem, then no issue existed. An independent mechanic suggested the symptoms may indicate a vacuum leak affecting the brake booster system, which could explain the excessive pedal force required during startup. However, to the best of my knowledge, neither dealership has performed a thorough investigation of the brake booster or vacuum system.

Premature clutch failure around 20,000 miles. It happened the first time the 4WD was engaged. Vehicle is in limp mode and cannot drive. There were no warnings prior to the issue. Previous year models have had NHTSA recalls issued for clutch failures.

I. Dash lights go on and off intermittently 2. If you bump the gear shift lightly it comes out of gear.