Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2026 Nissan Frontier Crew CAB — assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its 17-character VIN to decode that exact car — its engine, trim, assembly plant and factory equipment — alongside these records. Free, no account.
Run a VIN →Recalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Nissan Frontier Crew CAB year.
No EPA fuel-economy match for this model (naming may differ or it predates EPA records).
NHTSA frontal crash test
Rated configuration: 2026 NISSAN FRONTIER CREW CAB PU/CC N/A 4WD
The parts named most often across 5 owner complaintsfiled with NHTSA for this make, model and year — the closest free answer to “what is likely to go wrong?”
Complaints are self-reported and skew toward problems people find alarming, so treat this as where to look, not a defect rate.
Drive shaft/ Drive line noise concern with being disabled. Dealer confirmed noise states "repair under review"
Aftermarket vehicle equipment (Rough Country Hard Tri-Fold Flip Up Bed Cover, SKU: 49520551A) suffered a catastrophic structural hardware failure while traveling at highway speeds (approx. 70 MPH) on the interstate. Both the primary latching clamps and the factory-installed secondary safety retention straps failed simultaneously under standard operating conditions. The entire cover detached from the vehicle and launched into the roadway, creating an immediate, severe collision hazard for trailing motorists. Physical inspection of the truck bed afterwards revealed the mounting rails remained securely attached to the truck, but the integrated screw-handle anchoring hardware on the cover itself had completely failed and sheared off.
While driving North on I79 in dayligh I attempted to engage adaptive cruse control. The indicator lights on the dashboard were too dim to be visible and I was unable to tell if cruise control was on or determine what the speed setting was. After successfully engaging the control using buttons on the steering wheel the truck began accellerating strongly. I was unable to tell what the speed setting was but it must have been in excess of 80 mph as I had to turn the control off at that point. I returned truck to dealer and was told that lack of brightness for this indicator (and several others, such as turn signal indicators) was a design issue and could not be repaired by the dealer. I have tried every remidy I could find, even had the dealer's sales person take pictures of the dash while driving to verify the issue.
Purchased new 12.12.25, drove 3 miles and heard clunk in transmission, went into limp mode at mile 23. Flatbed back to dealer, they replaced Solenoid valve and said was good to drive. Drove away and still have loud clunk in transmission on downshifting. 1.5.26 Dealer still has vehicle, no resolution
The contact owns a 2026 Nissan Frontier. The contact stated that after the vehicle had gone through a carwash, the contact noticed that the fuel door was open. The contact stated that the failure recurred upon taking the vehicle to the carwash a second time. The vehicle was taken to the dealer, where the contact was advised to apply magnets to the fuel door to keep the door closed. The vehicle was not repaired. The contact expressed safety concerns because the issue could cause the vehicle to experience a safety failure. The manufacturer was notified of the failure, and a case was filed. The contact had missed and had attempted to return the case manager's phone call, but the case manager was unreachable. The failure mileage was approximately 275.
HTTP 400 Bad Request