Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2025 Toyota Crown Signia Hybrid, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Toyota Crown Signia Hybrid year.
No EPA fuel-economy match for this model. Naming may differ, or it predates EPA records.
Rated configuration: 2025 Toyota CROWN SIGNIA HYBRID SW AWD
The parts named most often across 13 owner complaints filed with NHTSA for this make, model and year.
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
Bridgestone tires were out at 18 k. The tires were roared by Toyota and aligned. This is a safety item and a fleet defect
One of the USB-C charging ports caved into the dashboard only several months after purchasing the car, resulting an oddly hole on the dashboard and non functional charging port.
The contact's wife owns a 2025 Toyota Crown Signia. The contact received notification of NHTSA Campaign Number: 25V595000 (Electrical System); however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.
The contact owns a 2025 Toyota Crown Signia. The contact stated that while driving at an undisclosed speed, the instrument panel became inoperable, and the display screen appeared blank. The contact received notification of NHTSA Campaign Number: 25V595000 (Electrical System); however, the part for the recall repair was not yet available. The vehicle was taken to a dealer, but was not diagnosed or repaired. The dealer confirmed that parts were not yet available. The contact expressed concerns that the failure was hazardous and rendered the vehicle unsafe to drive. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The approximate failure mileage was 6,500. The VIN was not available.
A few weeks after purchasing this vehicle in Dallas, TX we drove to Florida. About 4 hours into the trip we stopped for lunch and noticed both of our cells phones had not charged and in fact had discharged quite a bit. Further testing shows none of the front or rear USB Type-C ports would charge any cell phone we plugged into them. I purchased a USB volt meter and verified that the car would only send a small fraction of an amp to any cell phone plugged into these four ports. After discussing it with the dealer we tried different phones, different cables, and even every new Toyota on the show room floor. No single vehicle's front or rear Type-C ports would charge any cell phone we tried. Since then we have tried 4 friends Lexus vehicles and found the same issue exists in all of them. Any Type-C port labeled with a lightning bolt (i.e. a charging port) will not charge any phone we've tried. Any Type-C port that is marked as a data port will charge the phone. We have tried 5 different Samsung and 3 different iPhones and none will charge in the Type-C ports marked as charging ports. All phones and cables we've tested work with all home chargers and every other vehicle make and model we've tested with. The Samsung phones we have quick access to and originally used in testing are S21, S24, and A54. The iPhones are about two year old models.
The Toyota Crown Signia Tire Pressure Monitoring gauge has to be reset to properly display on each start versus staying in place on the drivers monitoring dashboard. All other driver monitoring aids, once selected to display on the monitoring dash, stay in place per each start cycle. This has existed as a vehicle defect from day 1. Many others have noted the same issue on various Crown Signia bulleting boards. The tire pressure monitoring is important as this vehicle has: 1. No spare, and weighs over 4,200 lbs. 2. The limited model in on 21 inch rims, and runs 235/45R21 tires, ie., very low profile. As such, this should be fixed immediately to ensure this critical information, once set up for monitoring, stays in place for driver monitoring.
When leaning on the front seat center armrest, the armrest makes a clicking noise when hitting rough or bumpy roads. The Toyota dealer replaced the armrest, and the same issue occurred. Toyota told the dealer they want the part to investigate further.
While driving less than 10 mph, (slightly down hill) approaching the house garage, the car suddenly accelerated and the brake was applied to stop but the car continued and smashed through the garage door, proceeded through garage, smashed through the back of garage, hit a Weber gas grill, proceeded over a low-level deck and hit a large tree. The impact force of the car (left front) against the tree caused the car rear end to rise up and move 30 degrees to the right and land on the low-level deck. The driver was the only person in the car and suffered a broken right wrist and contusions to her chest. Both Front air bags did not deploy, side air bags did deploy. There was no warning given and the Car collision avoidance system did not stop the car. The damage to car was total. Car Emergency Voice activated and assisted in notifying ambulance and police. Insurance has reviewed the damage, but I am not aware that they are investigating for cause. There has been one other sudden acceleration reported of a 2025 Crown Signa. There is history of malfunctions of the Electronic Throttle Control (ETC) (per Google). There is an Event Data Recorder (EDR) on the car, but I don't know what is on it. This needs to be investigated. (If this unintended acceleration happened in a grocery parking lot, or on a highway, there could have been serious injuries or a death).
As I was driving down a suburban road at about 30mph the brakes suddenly came on by themselves for few seconds as I approached a parked car on my right side. As I started to pass this car my vehicle continued moving forewarned and I did not come to a complete stop. There were no cars in front or behind me except for the one car parked to my right. There were two electric beeps when the car braked.
Driver headlight is lower than passenger headlight creating a big dark side on driver side. Dealership say it can’t be corrected
Two issues: 1. Low-beam headlights shine way too low on the road and unsafely prevent adequate vision of potential road hazards or oncoming cars, and my model "Limited" only has "automatic headlight leveling" without any way to manually set level to raise up the beam to a safe level. 2. Low-beam headlights cast on the road a distracting dark outline of an attachment or harness plug attached to the LED bulb.
The car was leased on 12/18/2024. On 01/24/2025, after starting the vehicle, the check engine light came on with the description: "a malfunction in the electronic control of the engine, throttle, or automatic transmission has been detected. Contact your Toyota dealer to have your vehicle inspected." I am attempting to get an appointment now to get the car in for service but being a month old - this shouldn't be happening.
Showing 12 of 13 complaints.
HTTP 400 Bad Request