Open safety recalls, the components owners report failing most often, crash-test results and running costs for the 2012 Nissan Altima, assembled from NHTSA and EPA records.
Everything on this page applies to the model as a whole. Run its VIN to decode that exact car, its engine, trim, assembly plant and factory equipment, alongside these records.
Open a VIN recordRecalls and complaints are filed against a specific model year, so figures differ from one year to the next even within a single generation. See every Nissan Altima year.
NHTSA lists 4 recalls for this make, model and year. Recalls apply to the model, so some may already be fixed on this specific car. A dealer can confirm from the VIN.
Issue: NISSAN IS RECALLING CERTAIN MODEL YEAR 2012 ALTIMA AND VERSA VEHICLES. THESE VEHICLES MAY BE EQUIPPED WITH SIDE CURTAIN AIR BAGS THAT CONTAIN AN INCORRECT PROPELLANT MIXTURE FOR THE INITIATOR COMPONENT USED, RESULTING IN INSUFFICIENT OUTPUT OF COMPRESSED GAS.
Risk: THE SIDE CURTAIN AIR BAGS MAY NOT DEPLOY, INCREASING THE RISK OF INJURY.
Remedy: NISSAN WILL NOTIFY OWNERS, AND DEALERS WILL REPLACE ONE OR BOTH SIDE CURTAIN AIR BAG MODULES, AS NECESSARY, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 12, 2012. OWNERS MAY CONTACT NISSAN CUSTOMER SERVICE AT 615-725-1000.
Campaign 12V055000
Issue: NISSAN IS RECALLING CERTAIN MODEL YEAR 2012 NISSAN ALTIMA VEHICLES MANUFACTURED FROM JUNE 15, 2011, THROUGH JUNE 21, 2011 AND MODEL YEAR 2012 NISSAN NV VEHICLES MANUFACTURED FROM JUNE 23, 2011, THROUGH JUNE 28, 2011 BECAUSE THE AIR BAG CONTROL UNIT (ACU) WAS ASSEMBLED INCORRECTLY.
Risk: THE AFFECTED ACU WILL NOT OPERATE AS DESIGNED AND THIS ISSUE MAY CAUSE THE AIR BAGS NOT TO INFLATE IN A CRASH WHEN THEY ARE DESIGNED TO INFLATE. THIS COULD INCREASE THE RISK OF INJURY.
Remedy: NISSAN WILL REPLACE THE AIR BAG CONTROL UNIT FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 22, 2011. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Campaign 11V408000
Issue: Nissan is recalling certain model year 2012-2013 Altima vehicles manufactured from May 10, 2012, through July 26, 2012. These vehicles may have been equipped with transverse link bolts and power steering rack bolts that were not torqued to proper specification.
Risk: The affected bolts could become loose and fall out which may lead to a loss of vehicle control, increasing the risk of a vehicle crash.
Remedy: Nissan will notify owners, and dealers will tighten the bolts to the proper torque specifications. The safety recall is expected to begin during November 2012. Owners may contact Nissan Customer Service at 1-800-647-7261.
Campaign 12V494000
Issue: NISSAN IS RECALLING CERTAIN MODEL YEAR 2011-2012 NISSAN ALTIMA SEDAN VEHICLES MANUFACTURED FROM APRIL 25, 2011, THROUGH JUNE 10, 2011 AT THE CANTON, MISSISSIPPI PLANT. THE TRANSVERSE LINK BOLT MAY NOT HAVE BEEN TORQUED TO THE PROPER SPECIFICATION. THIS CONDITION COULD CAUSE THE BOLT TO BECOME LOOSE WHILE THE VEHICLE IS BEING DRIVEN, CREATING A RATTLING NOISE AND VIBRATION.
Risk: IF THE BOLT COMES OUT COMPLETELY, THE DRIVER MAY EXPERIENCE DIFFICULTY CONTROLLING THE DIRECTION OF THE VEHICLE WHICH COULD RESULT IN A CRASH.
Remedy: NISSAN WILL REPLACE THE TRANSVERSE LINK BOLTS AND NUTS AND TIGHTEN THEM TO THE PROPER TORQUE SPECIFICATION FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 8, 2011. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Campaign 11V371000
The parts named most often across 425 owner complaints filed with NHTSA for this make, model and year.
1 crash · 1 injured
6 crashes · 5 injured
2 crashes · 1 injured
Took the car to a repair shop to get an alignment. Was told that the frame rear cross member was so rusty that it needed to be replaced, and that if it broke while driving I would lose control of the car. The component has not been removed from the car. No one else has looked at the car. Only prior warning/message/symptom was uneven rear tire wear first noticed about 6 months prior, but that may have been due to bad rear shocks.
Complaints are self-reported and skew toward problems people find alarming, so read this as where to look rather than as a defect rate.
I was working, and as I was on my way to a location a lady in front of me came to a complete stop since a couple of ducks were crossing causing me to come to a complete stop as well. As I stopped I looked into my rearview mirror I noticed the lady behind me was not stopping and then smashed into the back of me launching me into the car in front of me. My passenger air bag went off, however my driver seat airbag did not go off, failing to protect me. My car was completely totaled in result of the accident.
215/60/r16 Driving down, interstate st 70 steering wheel started to shake, then load noise as if running over something, then could see the entire middle tread of the tire flying into the lane behind me to the right. So luckily no one was in that lane or it would’ve crashed into the front of their car. Car was recently purchased from a dealer and the dealer had just gotten it from an auction so little to no information about the tires except for the date on the side, which was 0419, I assume April of 2019. Incident beyond panic caused tire tread to cut rear bumper in half as well as bending up metal positions, where the bumper attached to under the car. The tire also took out the entire inner fender well and smacked against the door in rear fender, causing damage. The tire remains inflated although all of the middle section is completely missing and wires are sticking out everywhere. The tires had just been rotated, and inspected and thankfully the failing tire was not on the front of the vehicle or it could’ve been much worse. Mechanic stated tread was OK. Tires looked OK and of course, made sure the correct psi was in them. The tire is available for inspection. The tire has not been looked at by anyone else the place were not involved and there was no warning light.
I am reporting a potential unintended automatic emergency braking event involving a 2025 Tesla Cybertruck. On 23Mar2026, at approximately 40 mph, I was traveling behind a Tesla Cybertruck on a public roadway. There were no visible obstacles, hazards, or debris in the roadway that I observed. The Cybertruck suddenly and aggressively braked without warning. The abrupt deceleration appeared inconsistent with road conditions and is consistent with what is commonly described as “phantom braking.” As a result of the sudden stop, I was unable to avoid a collision with the rear of the vehicle despite maintaining a reasonable following distance. After the impact, the Cybertruck initially left the scene, stating they were unaware a collision had occurred. No debris or roadway hazard was documented at the scene in the police report (FVPD report #2026-00777). The other driver later indicated a plastic bag may have triggered the vehicle’s emergency braking system. I am submitting this report as a potential safety issue involving unintended or inappropriate automatic emergency braking behavior.
There is a recall for the manufacturer emissions that the website doesn’t have on this car.
I drove out of town about 40 miles and everything was fine, next day went to leave to come home and immediately noticed high RPMs going about 20MPH. I pulled over, turned the car off and turned it back on, started driving and same thing. I had no choice but to drive it on the interstate. I could get up to 60 very carefully but I was still sitting around 4000rpms. It wouldn’t shift gears at all (I know it’s a CVT and doesn’t have gears). I then noticed a high squealing noise, thankfully made it home with a lot of honking and middle fingers even though I had my hazards on. Once I made it home, plugged in my OBD scanner and had a pending DTC of P1778 which I have found to be the stepper motor. Aka the death code. It’ll start, shift into all other gears, but is making a high squealing noise even when idle and in park and when revving in park the squeal gets louder. I even attempted the “semi manual’ to see if I could get it to catch, I couldn’t at all. No matter what “gear” I was in it wouldn’t bring the RPMs down.
The vehicle is unsafe to driver and others on the road. The power steering hose has had a leak since it was manufactured and was not fixed by the manufacturer at all! Tie rods gave away within 5 years of a mileage less than 24,200 miles. Cv joints along with tie rods have been easily compromised and damaged causing loss of control and steering .suspensions are no longer in tact nor reliable and will pose a danger. All errors were not found by manufacturer and has caused immediate danger to not only driver but everyone on the road. The engine has a rattle only after 2 years which is not usual.
The contact owns a 2012 Nissan Altima. The contact stated that while driving at an undisclosed speed and attempting to accelerate, the vehicle briefly lost motive power before slamming into gear. The contact stated that several unknown warning lights were illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the transmission. The vehicle was not repaired for the most recent failure. The contact stated that the vehicle was taken to several independent mechanics after purchasing the vehicle and the mass air flow, spark plugs, sensor coils, and other various engine parts and catalytic converters were replaced; however, the failure persisted. The manufacturer was notified of the failure. The failure mileage was unknown.
Clunking and bouncing from right tire followed by acceleration not working properly
The sensor was replaced but the light engine light still came back on now the speed sensor is causing the issue. The abs light comes on while accelerating it jumps and jerks
The contact owns a 2012 Nissan Altima. The contact stated while driving 40 MPH, there was an abnormal banging sound coming from the rear end of the vehicle, followed by a dragging sound. The contact also stated that the vehicle began to shake abnormally. There was no warning light illuminated. The contact pulled over and discovered that the rear driver side tire was hanging from the suspension. Due to the failure, the vehicle was towed to an independent mechanic where it remained. The manufacturer was notified of the failure but offered no assistance. The vehicle was not repaired. The failure mileage was approximately 236,000.
The transmissions go out fast in the ctv Nissan Altima 2012
Showing 12 of 425 complaints.
25.1 mpg average · 16–32 range · EPA says 26
Over 5 years this costs $750 more in fuel than an average new vehicle.
1 open NHTSA investigation into this model. Investigations come before recalls, so these are potential defects not yet covered by one.
Rated configuration: 2012 Nissan Altima 2 DR FWD